Product Name: Ld-787 Reverse Osmosis Membrane Fungicide Oxidizing Bactericide Model NO.: LD-787 Type: Industrial Circulating Water Treatment Agent Appearance: Liquid Color: Transparent Color Environmental Protection: Yes Certification: ISO9001 Trademark: Ludongchem Transport Package: Bucket Specification: 25kg/bucket Origin: Chinajinan HS Code: 3701367413 Product Description LD-787 RO BiocideProduct property: LD787 is a special non oxidizing bactericide for reverse osmosis system. It is used to sterilize the reverse osmosis membrane and ultrafiltration membrane system. Using it with the cleaning agent provided by our company, the cleaning effect of the membrane can be better and the frequency of cleaning can be reduced.LD787 can be added to the membrane system on-line or in the process of impact. It is effective for bacteria, fungi, yeasts, cyanobacteria and real algae. The time of germicidal effect is better than that of most other non-oxidizing fungicides, or even comparable to that of oxidizing fungicides.Product characteristics:1.Wide range of pH and good biodegradability.2.Germicidal broad spectrum, to a wide range of microorganisms are effective.3.Safe operation, non-combustion, non-volatile.4.Applicable to Dow Dow Chemical Company. Filmtecan, General Motors, Hydranauticsof the United States, Toray of Japan, Si-Han and other major manufacturers of all kinds of membrane products.Specification:Tems IndexAppearance colorless to pale green transparent liquidP H3-5Density(20 ºC)g/ cm31.05 ±0.05Ignition point:nonflammableUsage method:Reverse osmosis bactericide LD787 is used in the following two ways:1.On-line dosing: 30 minutes of impact treatment with 40-100ppm every 10 ~ 15 days can gradually destroy the biofilm scale formed on RO membrane surface and make it fall off with concentrated water.2.Off-line addition: stop RO system operation, use chemical cleaning method to configure bactericidal solution, and recycle the liquid to deal with the system. If the system is seriously polluted, the system shall be chemically cleaned in situ and then sterilized according to the following steps:Adding water to the cleaning tank and preparing the bactericide concentration of 100-500 ppm;Adjust the PH of cleaning liquid below 7 (citric acid or hydrochloric acid can be used to prolong the half-life of LD787Cycle 45 minutes.